Cats set with ship and stairway.

CLICK IMAGES TO ENLARGE
Working drawings
Go to previous page.

3D model of Glenn Jeffrey's design.

Note that this is a draft and may contain inaccuracies.

From the good seats.

[left] Shows the set with ship hidden and stairway up. The stairway is supported by a truss and while we are not worrying about the architecture of the warehouse, I thought another couple of trusses might mask the existence of the stair to heaven and also provide a "ceiling" to the set.

[lower left] The ship in.

[below] The stairway in.

From above.

From OP.

[left] Shows an indication of some textures - please note that these are only an approximation of Glenn's proposals. Also note that a lot of detail and "breaking-down" are not shown.

From PS.

[left] Shows stairway down.

Stairway in.

[left] Shows stairway down and a representation of the up-stage scaffolding and tower.

Rostra & Staging.

[top left] lowest level - 1530 high
plain rostra 4 x 1200 x 2400 x 1530, one long side clad
tunnel rostra 18 x 1200 x 2400 x 1530, 10 clad on one short side
ramps 2 x 6000 x 1200 x 0-1530, clad on one long side
DEC rostra (existing) 36 x 2000 x 1000 x 1530
curve-faced 2 x 4200 x 1900 x 1530

middle level - 1000 above lowest level
DEC rostra (existing) 12 x 2400 x 1200 x 1000
bevel faced 2 x 2400 x 1200 x 1000
bridge 1 x 2400 x 1200 x 150(?)

high level - 750 above middle level, 3400 above ground
ply sheets 17 x 2400 x 1200 on scaffolding

flats - uses approx 20 existing flats with a few modifications.

Working Drawings

Staging, Low level 1
Staging, Low level 2
Staging, Middle level 1
Staging, Middle level 2